Table of Contents
How do you change a transmission pan?
Changing a Transmission Pan Gasket
- Drain the fluid either though the drain plug or by loosening the pan.
- Remove the pan and old gasket.
- Clean the mating surfaces.
- Check the old transmission pan for flatness.
- Install the new transmission pan gasket and pan.
- Torque the bolts to the correct torque and in the correct sequence.
Where is transmission pan located?
The transmission’s pan is located at the very bottom of the transmission and faces the ground.
How long does it take to replace a transmission pan?
How long does it take to replace a transmission pan? To give you an approximation though, the required hours are probably in the range of 8 to 12 hours, based on the procedure set forth in the Factory Service Manual; the gasket is not easy to access and there is a lot of disassembly required.
How much does it cost to replace a transmission pan?
When the transmission oil pan is damaged, a lot can go into bringing back to life. In fact, replacing it is considered one of the toughest yet most expensive transmission repair jobs. The average cost of replacing a transmission pan ranges between $1800 to around $3500.
Can I drive my car with a transmission leak?
While it is not especially dangerous to continue driving with a leaking transmission fluid, it can cause catastrophic damage to your engine. As soon as you notice your car is leaking transmission fluid, you should seek to contact a certified mechanic to have your transmission fluid serviced.
Can a trans Pan be removed from a 4×4?
The transmission can now be lifted up with a floor jack from the rear extension housing or the transfer case on 4X4s. The pan will now clear the valve body without damaging any wires and connectors to the solenoids. The best way to do this is to remove the 2 bolts on the side of the transmission that hold the shift linkage bracket.
How to replace transmission pan 99-13 Chevy Silverado?
Take your new transmission pan and put the gasket into place and feed the bolts up through the holes. The gasket will hold the bolts into place. You don’t need to do this with all the bolts, just a few of them, enough to get it started.
What should I do if I Drop my Trans Pan?
Never bend this bracket as it can cause the transmission linkage to be out of adjustment. Next remove the 2 transmission mount bolts. The transmission can now be lifted up with a floor jack from the rear extension housing or the transfer case on 4X4s. The pan will now clear the valve body without damaging any wires and connectors to the solenoids.
What’s the best way to clean a transmission pan?
We’re just going to use some air tools to speed up the process. Now, tap the pan with a hammer and pull it down. Now, using a pry bar, pry between the transmission case and the bracket for the shift cable and pry that bracket out and then pull the pan down. Then once you get the pan out of the way, make sure you clean off the rim very well.