Table of Contents
How do you clear the error code on a Whirlpool oven?
Plug the oven power cord back in or turn ON circuit breaker. Press CANCEL on the display. If fault code comes back after 1 minute then replace the keypad. If F2 E0 persists then replace the electronic oven control.
What does F7 mean on my Whirlpool microwave?
ANSWER Dave, The F7 Error code indicates that power to the magnetron was interrupted. Unplug microwave oven or disconnect power.
How do I reset my Whirlpool oven control panel?
Reset power to the product:
- Power unit down by turning off the circuit breaker(s) for one (1) minute.
- Power unit up by turning on the circuit breaker(s).
- Start a bake cycle.
- Monitor the oven for one (1) minute to ensure the error code does not display again.
- Verify oven operation.
Is there a reset button on Whirlpool oven?
Press the “Off/Clear’ button for three seconds to turn the “Control Locked” child lock off. Reset the cooking program if “Off/Clear” was pressed accidentally. For example, press the “Defrost” button again, and turn the dial to select the defrost time you want again.
What does CLR mean on Whirlpool oven?
You don’t mention any other problems or if you can select and change cycles but “CLR” is short for “Clear” and would indicate a problem with the over control. Check if the control lock is turned on by pressing and holding the “Start” keypad for 3 seconds and see if the “Loc” light goes out or comes on.
What does f1 mean on Whirlpool oven?
This error code indicates the electronic control has detected an internal malfunction or it could have sensed a runaway temperature condition. The sensor will need to be checked first before replacing the control. To check the sensor set the oven temperature to 350 and let it cycle at least 3 times.
Why did my Whirlpool oven stop working?
If an oven won’t turn on there could be an incoming power problem. One of the wires that supply power to the oven element or igniter might be burnt out. These wires commonly burn out near the heat source. To determine if a wire has burned out, inspect the wires leading to the element or igniter.
Is there a reset button on my Whirlpool oven?
Press the “Off/Clear’ button for three seconds to turn the “Control Locked” child lock off. Reset the cooking program if “Off/Clear” was pressed accidentally. For example, press the “Defrost” button again, and turn the dial to select the defrost time you want again. Press “Start.”