Table of Contents
- 1 Where is the AC low pressure switch located?
- 2 Where is the AC compressor switch?
- 3 How do you replace a low pressure switch on an air conditioner?
- 4 How does a low-pressure switch work?
- 5 How does a AC low pressure switch work?
- 6 Where is the a / C pressure switch on a Chevy?
- 7 Do you need to evacuate the a / C system before replacing the pressure switch?
Where is the AC low pressure switch located?
The low side service valve is located in the line that runs from the compressor through the evaporator (firewall) and up to the condensor on the low pressure (suction) side of the system.
Where is the AC compressor switch?
The AC pressure switch is a safety switch that is mounted on both the high and low sides of the air conditioning system. It monitors the pressure of the refrigerant on its respective side of the system.
How do you replace a low pressure switch on an air conditioner?
- Step 1: Locate the A/C pressure switch.
- Step 1: Disconnect the negative battery cable.
- Step 2: Remove the switch electrical connector.
- Step 3: Remove the switch.
- Step 1: Install the new switch.
- Step 2: Reinstall the electrical connector.
- Step 3: Reinstall the negative battery cable.
- Step 4: Test the A/C.
What causes low pressure switch trip?
Things that can cause the low-pressure switch to trip include: Low refrigerant charge because of a refrigerant leak. Blower motor failure in the air handler. Plugged evaporator coils or a blockage of airflow.
What does a AC low pressure switch do?
The low pressure switch monitors the refrigeration system for a loss of refrigerant charge, and may also be helpful in stopping the evaporator (indoor) coil from freezing up due to a dirty filter or low airflow over the coil.
How does a low-pressure switch work?
A low-pressure switch is connected to the suction, or “low” side of the system to sense suction pressure. When the pressure in the system exceeds the high pressure switch setting, the switch will open circuit the compressor clutch and the compressor will stop circulating refrigerant.
How does a AC low pressure switch work?
The AC pressure switch is a safety switch mounted on the upper and lower sides of the air conditioning system. When the pressure goes up too high or falls too low (on the side of the system where the sensor is mounted), the switch turns off the compressor to avoid damage.
Where is the a / C pressure switch on a Chevy?
Low pressure will destroy a compressor through a lack of oil, and must therefore be repaired as soon as possible. Locate the high- and the low-side switches. The high-side switch is located on the smaller of the two air conditioning lines close to the radiator on the passenger side of the vehicle.
Where are the low and high AC pressure switches located?
The low-pressure side switch is found before the AC compressor, while the high-pressure switch comes after the compressor. Most AC pressure switches are found within the engine compartment, but some manufacturers put them elsewhere. A look in your service manual will show you the appropriate location for your model. AC Pressure Switch Function
Why is there a pressure switch on my AC unit?
It is responsible for monitoring refrigerant levels on both the low- and high-pressure sides of the AC unit. That’s why you have two separate AC pressure switches on your vehicle. One monitors the high-pressure side, while the other is evaluating the low-pressure aspects.
Do you need to evacuate the a / C system before replacing the pressure switch?
Note: Typically, the A/C system does not need to be evacuated prior to removing the A/C pressure switch. This is because there is a schrader valve built into the switch mount. If you have any doubt as to the design of your system, consult the factory repair information before switch removal.