Table of Contents
How many hoses are on a coolant reservoir?
Radiator Hose. Most vehicle cooling systems are comprised of four main hoses. The upper radiator hose is connected to the thermostat housing and to the radiator. From the bottom of the radiator, is the lower radiator hose that is directed to the water pump.
How many parts of coolant should be in water?
The mixing ratio of water and antifreeze should lie between 60:40 and 50:50. This usually corresponds to antifreeze protection from -25°C to -40°C. The minimal mixing ratio should be 70:30 and the maximal 40:60. Further increasing the proportion of antifreeze (e.g. 30:70) does not lower the freezing point any further.
What is the coolant valve?
Coolant switch valves control the coolant flow in side-flow cooling circuits of the powertrain and in the heating circuits of passenger compartments. In hybrid and electric vehicles, they can be used for coolant flow distribution, e.g. for cooling the battery and power electronics.
What permits coolant circulation through the engine when the thermostat is closed?
The thermostat is located between the engine and the radiator. This little temperature-sensitive spring valve stays closed during engine warm-up. When the thermostat is closed, it prevents coolant from leaving the engine and circulating through the radiator until the correct running temperature is reached.
The new Navigator Thermostatic Mixing Valve delivers tempered water to the faucet during regular use such as handwashing. In an emergency, the valve delivers tepid water to the emergency safety eyewash to meet the ANSI/ISEA Z358.1 required 15-minute flush.
What are the benefits of a navigator valve?
Navigator valves precisely control output temperature and provide protection from variations in input temperature and pressure. This built-in anti-scald protection is another benefit of this compact easy-to-use line of valves. Lead-free.
Navigator EFX valves are designed for this very purpose. Adjustable set point temperature range 65°F to 95°F (18°C to 35°C). Factory set point is 85°F (29°C) Maximum inlet temperature of 180°F (82°C) with recommended inlet temperature of 120°F to 140°F (49°C to 60°C)
What is the water temp of Bradley navigator?
Bradley’s Navigator standard valves are ASSE 1017 and cUPC certified, providing long-lasting reliable service. The point-of-use valves work at the fixture for showers and sinks. They reliably control water temperature at flow as low as 0.35 gpm (1.32 lpm). Protect your users with these anti-scald valves.